Datalogic QLM500 Instruction Manual download pdf (Page 105)

TYPICAL LAYOUTS

In this layout a single reader functions as a Slave node on a Fieldbus network. The data is

transmitted to the Host through an accessory Fieldbus interface board installed inside the

CBX500 connection box.

Reader configuration can be accomplished through the Auxiliary interface using the VisiSet™

configuration program or Host Mode programming.

In Local Echo communication mode, data is transmitted on the RS232 auxiliary interface

independently from the Fieldbus interface selection.

When One Shot or Phase Mode operating mode is used, the reader can be activated by an

External Trigger (photoelectric sensor) when the object enters its reading zone.

Figure 102 – Fieldbus Interface Point-to-Point Layout

Matrix 410™

 Fieldbus Interface (Profibus, DeviceNet, etc.)

 Auxiliary Serial Interface (Local Echo) (RS232)

 External Trigger (for One Shot or Phase Mode)

Host

Power

CBX500

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 160 161

No comments

Datalogic QLM500 Instruction Manual Page 105