Datalogic QLM500 Instruction Manual download pdf (Page 103)

TYPICAL LAYOUTS

6 TYPICAL LAYOUTS

The following typical layouts refer to system hardware configurations. However, they also

require the correct setup of the software configuration parameters. Dotted lines in the figures

refer to optional hardware configurations within the particular layout.

6.1 POINT-TO-POINT

In this layout the data is transmitted to the Host on the main serial interface. The RS232

auxiliary interface can be used for reader configuration by connecting a laptop computer

running VisiSet™. Host Mode programming can be accomplished either through the main

interface or the Auxiliary interface.

In Local Echo communication mode, data is transmitted on the RS232 auxiliary interface

independently from the main interface selection.

When One Shot or Phase Mode operating mode is used, the reader can be activated by an

External Trigger (for example a pulse from a photoelectric sensor) when the object enters its

reading zone.

Figure 99 – Serial Interface Point-to-Point Layout

Figure 100 – Serial Interface Point-to-Point Layout

Terminal

Matrix 410™

 Main Serial Interface (RS232 or RS485 Full-Duplex)

 Auxiliary Serial Interface (Local Echo) (RS232)

 External Trigger (for One Shot or Phase Mode)

Host

PG6000

CBX

CAB-MSxx

Matrix 410™

with Ultra

High Power

illuminator

 Main Serial Interface (RS232 or RS485 Full-Duplex)

 External Trigger (for One Shot or Phase Mode)

Host

PG6000

CBX

CAB-MSxx

CAB-LP-0x

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 160 161

No comments

Datalogic QLM500 Instruction Manual Page 103