CBX ELECTRICAL CONNECTIONS
4.2.2 RS485 Full-Duplex Interface
The RS485 full-duplex (5 wires + shield) interface is used for non-polled communication
protocols in point-to-point connections over longer distances (max 1200 m / 3940 ft) than
those acceptable for RS232 communications or in electrically noisy environments.
The CBX pinout follows:
Figure 50 - RS485 Full-duplex Connections
For applications that do not use RX485 signals, do not leave these lines
floating but connect them to SGND as shown below.
Figure 51 - RS485 Full-duplex Connections using Only TX Signals
Comments to this Manuals