Datalogic PowerScan PBT9500 Specifications download pdf (Page 32)

Enter/Exit Programming Mode

PowerScan™ PD9530/PBT9500/PM9500

• "2D Symbologies" on page 173 provides configuration of a personal-

ized mix of 2D codes, code families and their options.

You must first enable your reader to read bar codes in order to use

this section. If you have not done this, go to

Setup, starting on

page 7

and complete the appropriate procedure.

To program features:

1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of

each programming page, when applicable.

2. Scan the bar code to set the desi

red programming feature. You may

need to cover unused bar codes on the page, and possibly the facing

page, to ensure that the reader reads only the bar code you intend to

scan.

3. If additional input parameters ar

e needed,

go to Appendix D, Keypad,

and scan the appropriate characters from the keypad.

Additional information about many features can be found in the “Ref-

erences” chapter.

If you make a mistake before the last character, scan the CANCEL bar

cod

e to abort and not save the entry string. You can then start again

at the beginning.

4. Complete the programming sequence by scanning the ENTER/EXIT

PROGRAMMING bar code to exit Programming Mode.

For more detailed descriptions, progr

mming information and examples for

setting selected configuration items, see References, starting on page 271.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 361 362

No comments

Datalogic PowerScan PBT9500 Specifications Page 32