Datalogic PowerScan PBT9500 Specifications download pdf (Page 294)

References

284

PowerScan™ PD9530/PBT9500/PM9500

5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Prog Mode.

Set Length 2

This feature allows you to set one of the bar code lengths for the specified

symbology. Length 2 is the maximum label length if in Variable Length

Mode, or the second fi

xed

length if in Fixed Length Mode. See the page for

the specific symbology for parameters.

The length that can be set varies depending on the symbology. A setting of

pecifies to ignore this length (only one fixed length).

Follow these instructions to set this feature:

1. Determine the desired character

length (from 1 to 50 — or 0 to ignore

this length). Pad the number with leading zeroes to yield two digits. For

example: 0 = 00, 5 = 05, 20 = 20, etc.

2. Go to the Set Length page for your se

lected symbology and scan the

ENTER/EXIT PROGRAMMING MODE bar code to enter Programming

Mode.

3. Scan the bar code to SELECT LENGTH

2 SETTING for your selected sym-

bology.

4. Scan the appropriate two digits from the keypad in Appendix D, Keypad

that represent the length setting which was determined in the steps

above. You

will hear a two-beep indication after the last character.

If you make a mistake, before the last character scan the CANCEL bar

code to abort and not save the entry string. You can then start again

at the beginning.

5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-

ming Mode.

This completes the procedure.

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 361 362

No comments

Datalogic PowerScan PBT9500 Specifications Page 294