Datalogic PowerScan PBT9500 Specifications download pdf (Page 292)

References

282

PowerScan™ PD9530/PBT9500/PM9500

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface.

The selectable range for this feature is from 0 to 99 seconds.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the number with leading zeroes to yield two digits. For example: 0

00, 5 = 05, 20 = 20, etc

3. Go to page 42 and scan the ENTER/EXIT PR

OGR

AMMING MODE bar code

to enter Programming Mode.

4. Scan the bar code: SELECT INTERCODE DELAY SETTING.

5. Scan the appropriate two digits from the keypad in Appendix D, Key-

pad, that represent the duration which was determined in the steps

above. You will hear a two-beep indication after the last character.

If you make a mistake before the last character, scan the CANCEL bar

code to abort and not save the entry string. You can then start again

at the beginning.

6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-

ming Mode.

This completes the procedure. See Table 37 for some examples of how to

set this feature.

Table 37. Wedge Intercode Delay Examples

STEP ACTION EXAMPLES

1 Desired Setting

No Delay 5 Seconds 60 Seconds 99 Seconds

2 Pad with leading zero(es)

00 05 60 99

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT INTERCODE DELAY SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘0’ ‘0’ and ‘5’ ‘6’ and ‘0’ ‘9’ AND ‘9’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 361 362

No comments

Datalogic PowerScan PBT9500 Specifications Page 292