Datalogic PowerScan PBT9500 Specifications download pdf (Page 308)

References

298

PowerScan™ PD9530/PBT9500/PM9500

Aiming Duration Time

Specifies the frame of time the aiming pointer remains on after decoding a

label, when in trigger single mode. The range for this setting is from 1 to

255 seconds in 1-second increments.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the result with leading zeroes to yield three digits. For example: 0

= 0

00, 5 = 005

, 20 = 020, etc.

3. Go to page 76 and scan the ENTER/EXIT PROGR

AMMING MODE bar code

to enter Programming Mode.

4. Scan the bar code: SELECT AIMING DURATION TIME SETTING.

5. Scan the appropriate three digits from the keypad in Appendix D, Key-

pad, that represent the duration which was determined in the steps

above. You will hear a two-beep indication after the last character.

If you make a mistake before the last character, scan the CANCEL bar

code to abort and not save the entry string. You can then start again

at the beginning.

6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-

ming Mode.

This completes the procedure. See Table 43 for some examples of how to

set this feature.

Table 43. Aiming Duration Time Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

1 Second 90 Sec. (1.5 min.) 180 Sec. (3 min.)

255 Seconds (4.25

min

2 Pad leading zero(es)

001 090 180 255

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT AIMING DURATION TIME SETTING

Scan Three Characters

From

Appendix D,

Keypad

‘0’, ‘0’ and ‘1’ ‘0’, ‘9’ and ‘0’ ‘1’, ‘8’ and ‘0’ ‘2’, ‘5’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 303 304 305 306 307 308 309 310 311 312 313 ... 361 362

Comments to this Manuals

No comments

Datalogic PowerScan PBT9500 Specifications Page 308

Comments to this Manuals

Related products and manuals for Bar code readers Datalogic PowerScan PBT9500