Datalogic PowerScan PBT9500 Specifications download pdf (Page 313)

Motion Features

Product Reference Guide

303

Motion Features

Motionless Timeout

This setting specifies the amount of time that the reader takes to assume

that it is in a motionless condition. The range for this setting is from 500

msec to 25.5 seconds, in 100 millisecond increments.

Follow these instructions to set this feature.

1. Determine the desired setting.

2. Pad the result with leading zeroes to yield three digits. For example: 0.5

= 0005 = 00, 5 = 050, 20 = 200, etc.

3. Go to page 206 and scan the ENTER/EXIT PROGRAMMING MODE bar

code to enter Programming Mode.

4. Scan the bar code: SELECT MOT

ONLESS TIMEOUT SETTING.

5. Scan the appropriate three digits from the keypad in Appendix D, Key-

pad representing the duration which was determined in the steps

above. You will hear a two-beep indica

tion after the last character.

If you make a mistake before the last character, scan the CANCEL bar

code to abort and not save the entry string. You can then start again

at the beginning.

6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-

ming Mode.

This completes the procedure. See Table 48 for examples of how to set this

feature.

Table 48. Motionless Timeout Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

500ms 1 sec. 10 sec 9,900ms (9.9 sec.)

Divide by 100 (and pad

with leading zeroes to yield

two digits

)

005 010 100 250

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT MOTIONLESS TIMEOUT SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’, ‘0’ and ‘5’ ‘0’, ‘1’ and ‘0’ ‘1’, ‘0’, and ‘0’ ‘2’, ‘5’, and ‘0’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 308 309 310 311 312 313 314 315 316 317 318 ... 361 362

No comments

Datalogic PowerScan PBT9500 Specifications Page 313