Datalogic Controller SC6000 Installation Manual download pdf (Page 32)

BHS AND REDS INSTALLATION MANUAL

4.3.3 Manual PackTrack™ Calibration

PackTrack calibration is needed on a new reader. It is performed by Genius™ through the

SPY add-on. The PackTrack calibration procedure is different for DS8100A and DX8200A

readers.

1. Double click the icon of the scanner to calibrate. Enter the SPY add-on

2. On the Menu Bar select Tools and PackTrack calibration to obtain the following window:

DS8100A PackTrack Calibration

3. Select an origin for the coordinate system on the real conveyor.

The conveyor’s side rail is X=0. You can use either the inside or the outside edge

depending on how the conveyor is constructed. It does not matter as long as you are

consistent. It’s best to mark it on the conveyor and write it on paper to be left inside an

appropriate pocket inside power supply door.

The presence sensor line is used as the Y=0 line. It helps to lay a spare piece of Bosch

frame or other heavy, straight material across the conveyor as a reference for your tape

measure.

The surface of the conveyor is the Z=0 reference.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 77 78

No comments

Datalogic Controller SC6000 Installation Manual Page 32