BHS AND REDS INSTALLATION MANUAL
Encoder diagnostics affects the
switch over
Encoder Failure Event
Filter
Number of times the alarm must be
repeated before the switch over
occurs
Check Max Consecutive
Lost Parcels
Max Consecutive Lost Parcels
affects the switch over
Max Consecutive Lost
Parcels
Number of Lost parcels recognized
by the Standby controller before the
switch over occurs
Check Max % Of Lost
Parcels (Out Of 100
Parcels)
Max % Of Lost Parcels affects the
switch over
Max % Of Lost Parcels
(Out Of 100 Parcels)
Percentage (number) of Lost
parcels recognized by the Standby
controller before the switch over
occurs
Data Communication
Settings
\Built-in
Ethernet\LineParameters
Data Communication
Settings
\Additional
Ethernet\LineParameters
Only Dual Ethernet Models
Digital I/O Setting\Digital
Output Lines
Setting\Output 6
Local/Built-in
EthernetIP/ Built-in
Profinet/Additional
EthernetIP/ Additional
Profinet/Profibus/Redun
dancy
Usage of OUT6: if set to
Redundancy, this digital output is
used to indicate the Active/Standby
status
Diagnostics
\Redundancy Diagnostic
Notification
Enable/Disable transmission of
REDS diagnostic on the Active
Master
Enable/Disable transmission of
REDS diagnostic on the Standby
Master
Comments to this Manuals