Datalogic QLM500 Installation Manual download pdf (Page 85)

TYPICAL LAYOUTS

In this layout a single scanner functions as a Slave node on a Fieldbus network. The data is

transmitted to the Host through an accessory Fieldbus interface board installed inside the

CBX500 connection box.

Scanner configuration can be accomplished through the Auxiliary interface using the

Genius™ configuration program or Genius™ based Host Mode programming.

In Local Echo communication mode, data is transmitted on the RS232 auxiliary interface

independently from the Fieldbus interface selection.

When On-Line Operating mode is used, the scanner is activated by an External Trigger

(photoelectric sensor) when the object enters its reading zone.

Figure 86 – Fieldbus Interface Point-to-Point Layout

DS2400N



Fieldbus Interface (Profibus, Ethernet, DeviceNet, etc.)



Auxiliary Serial Interface (Local Echo) (RS232)

 External Trigger (for On-Line Mode)

Host

Power

CBX500

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 118 119

No comments

Datalogic QLM500 Installation Manual Page 85