TECHNICAL FEATURES
0° to +45 C (+32° to +113 °F)
-35° to +45 °C (-31° to +113 °F)
-20° to +70 C (-4° to +158 °F)
-35° to +70 °C (-31° to +158 °F)
14 mm @ 2 to 10 Hz; 1.5 mm @ 13 to 55 Hz;
2 g @ 70 to 200 Hz; 2 hours on each axis
Protection Class – EN 60529
68 x 84 x 34 mm (2.7 x 3.3 x 1.3 in)
* EAN/UPC (including Add-on 2 and Add-on 5)
* Code 39 (Standard and Full ASCII)
up to ten different symbologies during one reading phase
can enable multiple good reads of same code
Up to 128-byte header string
Up to 128-byte terminator string
On-Line, Serial On-Line, Verifier,
Automatic, Continuous, Test
X-PRESS™ Functions
Genius™ utility program
Genius™ based Host Mode Programming
Code Verifier
ACR-Lite (Advanced Code Reconstruction)
Motor Off and SW_Speed Control
Programmable Diagnostic and Statistic Messages
Non-volatile internal Flash
Ready, Good, Trigger, Com, Status, Power On
If the reader is used in high temperature environments (over 40 C), use of the Beam Shutter is advised (see
the Genius™ configuration program) and/or a thermally conductive support (such as the metal bracket
provided).
The Operating Temperature is guaranteed under the following conditions:
no direct ventilation on the scanner
fixed working environment (no rapid temperature changes)
At -35 °C, a 20 min warm-up period is required before the scanner is ready to read barcodes.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email:
[email protected]
Comments to this Manuals