Datalogic QLM500 Installation Manual download pdf (Page 64)

DS2400N REFERENCE MANUAL

Pulled up to External

Input Device Power

Input

Signal

Input Device

Figure 56 - NPN Input 2 Using External Power

4.5.1 Code Verifier

If the DS2400N is used as a Code Verifier, the verifier code can be configured in software

through the Genius™ configuration program. However it is also possible to use one of the

inputs to trigger when the scanner should store a code read as the verifier code.

The Code Verifier parameter must be enabled, and the configuration parameters to allow

correct Code Type reading must be saved to the scanner in order to read the verifier code.

When the selected input is activated, the next read code will be stored as the verifier code in

the scanner's non-volatile (Flash) memory.

For more details see the Verifier Parameters in the "2K/4K Family Software Configuration

Parameter Guide” Help file".

4.6 OUTPUTS

Two general purpose outputs are available.

CBX100/500

Function

Power Source - Outputs

O1+

Output 1 +

O1-

Output 1 -

O2+

Output 2 +

O2-

Output 2 -

-V

Power Reference Outputs

The meaning of the two outputs Output 1 and Output 2 can be defined by the user (No Read,

Right, Wrong, etc.). Refer to the Genius™ Help On Line.

By default, Output 1 is associated with the No Read event, which activates when the code

signaled by the external trigger is not decoded, and Output 2 is associated with the Complete

Read event, which activates when all the selected codes are correctly decoded.

The output signals are fully programmable being determined by the configured

Activation/Deactivation events, Deactivation Timeout or a combination of the two.

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 118 119

No comments

Datalogic QLM500 Installation Manual Page 64