Datalogic QLM500 Installation Manual download pdf (Page 50)

DS2400N REFERENCE MANUAL

NOTE

To avoid electromagnetic interference when the scanner is connected to a

CBX connection box, verify the jumper positions in the CBX as indicated in

its Installation Manual.

4.1 POWER SUPPLY

Power can be supplied to the scanner through the CBX100/500 spring clamp terminal pins

as shown in Figure 38:

V+

Earth

Ground

Power Supply

VGND

Figure 38 - Power Supply Connections

The power must be between 10 and 30 Vdc only.

For DS2400N Subzero models using CBX100 LT the power must be 24 Vdc.

It is recommended to connect the device CHASSIS to earth ground (Earth) by setting the

appropriate jumper in the CBX connection box. See the CBX Installation Manual for details.

4.2 MAIN SERIAL INTERFACE

CAUTION

Do not connect to the Main Interface spring clamp terminals if using Host

Interface Modules (Fieldbus) with the CBX500.

The signals relative to the following serial interface types are available on the CBX spring

clamp terminal blocks.

If the interface type is not compatible with the current communication handshaking, then the

system forces the handshake to none.

The main interface type and the relative parameters (baud rate, data bits, etc.) can be

set using the Genius™ utility program or the Genius™ based Host Mode Programming

procedure.

Details regarding the connections and use of the interfaces are given in the next paragraphs.

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 118 119

No comments

Datalogic QLM500 Installation Manual Page 50