Datalogic QLM500 Installation Manual download pdf (Page 34)

DS2400N REFERENCE MANUAL

Reset Scanner to Factory Default

If it ever becomes necessary to reset the scanner to the factory default values, you can

perform this procedure by holding the X-PRESS™ push button pressed while powering up

the scanner. At the end of the procedure (about 5-6 seconds), the Configuration and

Environmental parameters are reset, all LEDs blink simultaneously 3 times and the message

"Default Set" is shown on the display.

2.4 SUBZERO TEMPERATURE MODELS

The DS2400N Subzero scanner is an industrial scanner designed to operate in industrial

refrigerator/freezer cells or other stable subzero degree environments, which are below the

operating range of standard industrial scanners. It is not designed to move between subzero

and normal environments (rapid temperature changes).

The DS2400N Subzero has an intelligent microprocessor-driven and efficient internal heating

system which constantly monitors and automatically controls internal temperature. Only the

necessary temperature-sensitive components are heated, resulting in an efficient heating

system which has very low power consumption.

Upon power-up in a subzero environment, the scanner waits until these internal components

are heated to within their operating temperature range. Power-up at -35 °C can take about 20

minutes before the scanner is ready to read barcodes. During this time the laser and motor

remain off and the Ready LED blinks, indicating the warm-up phase. While in the warm-up

phase, scanner communication is operative and the device can be configured through

Genius™ or through Host Mode Programming.

Internal Temperature (°C)

Scanner Normal Operation

Starting Point

Stabilized Temperature Phase

Warm-Up

Phase

Cold Start

Time (min)

-35

The DS2400N Subzero can be connected to the CBX100 LT Subzero connection box which

can withstand the same low temperature environment as the scanner. A CBX100 LT all-in-

one model includes a BM100 backup and restore module having an extended temperature

range also for use in subzero environments.

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 118 119

No comments

Datalogic QLM500 Installation Manual Page 34