Datalogic QLM500 Installation Manual download pdf (Page 19)

RAPID CONFIGURATION

Auto Setup (Optional)

At the end of the Auto Learn procedure, you have the possibility to follow the Auto Setup

procedure to set up the reading parameters.

1. Enter the Auto Setup function by holding the X-PRESS™ push button pressed until the

SETUP LED is on.

2. Release the button to enter the Auto Setup function.

3. Once entered, if a barcode label is positioned in front of the scanline, the scanner

automatically performs the optimal setup of the reading parameters for that specific

barcode.

green

yellow

red

SETUP

LEARN

TEST

READY

GOOD

TRIGGER

COM

STATUS

Figure 7 – X-PRESS™ Interface: Auto Setup Function

The procedure is as follows:

A) place the desired barcode on

the scanline.

B) enter the AutoSetup function

(the laser turns on and the

SETUP LED blinks to indicate

the ongoing process)

C) wait until the SETUP LED

stays steady on (indicating the

reader has detected the

barcode)

This procedure ends either when the barcode is successfully decoded or after a timeout of

about 7 (seven) seconds.

The scanner will restart at the end of the process, and then the optimized reading

parameters for that barcode are automatically configured in scanner memory.

NOTE

If your application has been configured using X-PRESS™, go to STEP 5.

Reset Scanner to Factory Default (Optional)

If it ever becomes necessary to reset the scanner to the factory default values, you can

perform this procedure by holding the X-PRESS™ push button pressed while powering up

the scanner. At the end of the procedure (about 5-6 seconds), the Configuration and

Environmental parameters are reset, and all LEDs blink simultaneously 3 times. If connected

through a CBX500 with display module, the message "Default Set" is shown on the display.

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 118 119

Comments to this Manuals

No comments

Datalogic QLM500 Installation Manual Page 19

Comments to this Manuals

Related products and manuals for Bar code readers Datalogic QLM500