Datalogic QLM500 Installation Manual Page 78

  • Download
  • Add to my manuals
  • Print
  • Page
    / 119
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 77
DS2400N REFERENCE MANUAL
66
5
5.3.3 ID-NET™ Network Termination
The network must be properly terminated by a 120 Ohm resistor at the first and last scanner
of the network.
5.4 AUXILIARY RS232 INTERFACE
The auxiliary serial interface is used exclusively for RS232 point-to-point connections.
The parameters relative to the aux interface (baud rate, data bits, etc.) as well as particular
communication modes such as LOCAL ECHO can be defined using the Genius™ utility
program or Genius™ based Host Mode Programming installed from the CD-ROM.
The following pins of the 25-pin connector are used to connect the RS232 auxiliary interface:
Pin
Name
Function
20
RX
Receive Data
21
TX
Transmit Data
7
GND
Ground
7
GND
GND
TXD
RX
20
RXD
TX
21
USER INTERFACE
DS2400N
1
Chassis
Figure 73 - RS232 Auxiliary Interface Connections
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]
Page view 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 118 119

Comments to this Manuals

No comments