Datalogic QLM500 Installation Manual download pdf (Page 60)

DS2400N REFERENCE MANUAL

4.3.3 ID-NET™ Network Termination

The network must be properly terminated in the first and last scanner of the network. This is

done by setting the ID-NET™ Termination Resistance Switch in the CBX100/500 to ON.

4.4 AUXILIARY RS232 INTERFACE

The auxiliary serial interface is used exclusively for RS232 point-to-point connections.

The parameters relative to the aux interface (baud rate, data bits, etc.) as well as particular

communication modes such as LOCAL ECHO can be defined using the Genius™ utility

program or Genius™ based Host Mode Programming installed from the CD-ROM.

The 9-pin female Auxiliary Interface connector inside the CBX is the preferred connector for

device configuration or communication monitoring.

Figure 49 - 9-pin female connector

If permanent system wiring is required, the following pins are used to connect the RS232

auxiliary interface:

CBX100/500

Function

Auxiliary Interface Receive Data

Auxiliary Interface Transmit Data

SGND

Auxiliary Interface Reference

RX TX

Reference

USER INTERFACE

Figure 50 - RS232 Auxiliary Interface Connections

NOTE

Do not connect the Aux Interface to the CBX spring clamp connectors and

the 9-pin connector simultaneously.

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 118 119

No comments

Datalogic QLM500 Installation Manual Page 60