Datalogic GWY-01-PBS-01 Specifications download pdf (Page 14)

GWY-01-DNT-01 MANUAL – REV. 02 CHAPTER 1:

GETTING STARTED

PAGE 14 OF 67

1.6 INSTALLING THE GATEWAY

The GWY-01-DNT-01 supports DeviceNet communications and can be connected to

a LAN and/or Programmable Logic Controller (PLC) via DeviceNet-compatible

cabling.

Follow the Steps Below to Install the Gateway

1. Note the Installation Guidelines in Chapter 1, Section 1.5

2. Securely mount the Gateway to your chosen location using two M5 (#10)

screws, lock washers and nuts. The Gateway may be mounted in any

orientation, but should be aligned in such a manner that the LED

indicators can be seen during operation.

3. Attach one end of a 5-pin, male-to-male, M12, ThinNet drop cable (EMS

P/N: CBL- 1481-XX) to the 5-pin, female, M12 connector on the

Gateway. Connect the other end of this 5-pin, male-to-male, M12,

ThinNet drop cable to the 5-pin, female, M12 connector on EITHER a

ThickNet to ThinNet Drop-T Connector OR a ThinNet to ThinNet

Drop-T Connector (as per your network and RFID application

requirements). See figure below for Drop-T connectors.

Figure 1-2: Drop-T Connectors and Terminating Resistors

4. Attach one end of a male-to-female trunk cable to each mating connector

on the Drop-T Connector. Continue connecting trunk cables and Drop-T

connectors as needed. Note: trunk length should not exceed 300m for

ThickNet and 20m for ThinNet.

5. Connect the male end of a 5-pin, male-to-female ThinNet drop cable to

the female end on your Drop-T connector(s). Attach the remaining

female end of the ThinNet drop cable to the 5-pin, male, M12 connector

on a Cobalt HF and/or C-Series Controller (RS485 models).

6. Repeat Step 5 for each RFID controller you plan to install. Note:

maximum drop cable length is 2m.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 66 67

No comments

Datalogic GWY-01-PBS-01 Specifications Page 14