Datalogic MAGELLAN 8400 Specifications download pdf (Page 66)

100

101

2-34 Magellan

8300/8400

Changing Weighing Modes

Your scanner/scale has been programmed for weighing in either pounds or

kilograms depending upon the initial operating environment that was

specified when you ordered your scanner/scale. If you need to change

from pounds to kilograms or vice-versa, call technical support.

You can verify that the scale is set correctly for your country’s requirements

by observing that the Remote Scale Display shows the appropriate mea-

surement symbol (lb or kg) when the power-up Selftest is completed.

Set-Up & Installation

These setup and installation procedures assume that you have already pre-

pared your checkstand to receive the scanner or scanner/scale. If you have

not already made the counter cutout and routed power and interface

cables, do so now as described in the previous instructions. If your check-

stand has been prepared, proceed as follows:

Set-up

1. Place the scanner on the checkstand next to the counter cutout.

2. Make all connections to peripheral devices, such as the Remote

Scale Display (see Figure 2-24) and, if your installation includes an

EAS system, refer to that manufacturer’s instructions for connection

and start-up procedures.

3. Route the cables up through the cutout and connect the scanner and

scale interface cable(s), EAS cable and Remote Scale Display cable

(optional) to the scanner. Some POS terminals require two interface

cables; one for the scanner interface and one for the scale interface.

Refer to Figure 2-26 for cable connection locations.

Any time the scale weighing mode is changed, the scale must be

re-calibrated before commercial use.

LEGAL NOTE

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 543 544

Comments to this Manuals

No comments

Datalogic MAGELLAN 8400 Specifications Page 66

Comments to this Manuals

Related products and manuals for Bar code readers Datalogic MAGELLAN 8400