Datalogic GRYPHON Specifications download pdf (Page 294)

References

292

Gryphon™ I GD4100/GM4100/GBT4100/L GD4300

• RTS/XON/XOFF — RTS is asserted during transmissions. CTS is ignored. XON and

XOFF gate transmissions.

• RTS On/CTS — RTS is always asserted. CTS gates transmissions.

RTS/CTS Scan Control — RTS is asserted during transmissions. CTS gates transmissions and

controls enable and disable state of scanner.

RS-232/USB COM Parameters

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the

beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in

10ms increments. A setting of zero specifies no delay.

To set the delay:

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-

ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

4. Go to page 47 and scan the barcode: SELECT INTERCHARACTER DELAY SET-

TING.

5. Scan the appropriate two digits from the keypad in Appendix D, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.

This completes the procedure. See Table 28 for some examples of how to set this feature.

Table 28. Intercharacter Delay Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

50ms 150ms 600ms 850ms

Divide by 10 (pad with leading

zer

oes to yield two-digits)

05 15 60 85

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT INTERCHARACTER DELAY SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘5’ ‘5’ and ‘0’ ‘6’ and ‘0’ ‘8’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 369 370

No comments

Datalogic GRYPHON Specifications Page 294