Datalogic CBX500 Installation Manual download pdf (Page 12)

STS400™ INSTALLATION MANUAL

Conveyor Operating Width: This is the effective operative width where the tires can run:

Operating

Width

Maximum Application FOV: This data is the maximum reading width where a barcode can

be found by the STS400™.

Because the barcode is located on or next to the Bead of the tire, the barcode will never be

found at the edges of the Conveyor Operating Width. The Maximum Application FOV

therefore can always be less than the Conveyor Operating Width:

FOV

Operating Width

The figure above shows a sectional view of the tires in order to better understand the

difference between the Maximum Application FOV and the Conveyor Operating Width.

The Maximum Application FOV can be calculated with the following formula:

FOV = Operating Width – 2 * (Minimum Tire Height – Barcode Position Margin)

The Barcode Position Margin takes into account the distance from the Bead where the

barcode could be applied.

Maximum Conveyor Speed: The STS400™ with factory default configuration can support

speeds up to 1 m/s (196.85 fpm, 60 m/min).

NOTE

Higher speeds can be obtained by modifying the configuration, please

contact your local Datalogic representative for feasibility.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 64 65

No comments

Datalogic CBX500 Installation Manual Page 12