Datalogic DS4800 Technical Information download pdf (Page 8)

DS4800 OM QUICK GUIDE

STEP 4 – X-PRESS™ CONFIGURATION

X-PRESS™ is the intuitive Human Machine Interface designed to improve ease of installation and maintenance.

Status and diagnostic information are clearly presented on the display (which can be configured in various

languages) and by means of the five colored LEDs, whereas the single push button gives immediate access to

the following relevant functions:

 AutoSetup to self-optimize and auto-configure reading

performance in demanding applications

 AutoLearn to self-detect and auto-configure for reading

unknown barcodes (by type and length)

 Focus Lock to memorize the mechanical focus position

 Test Mode with bar-graph visualization to check static readin

performance

The colors and meaning of the five LEDs are illustrated in the following table:

READY (green) This LED indicates the device is ready to operate.

GOOD (green) This LED confirms successful reading.

TRIGGER (yellow) This LED indicates the status of the reading phase.

COM (yellow) This LED indicates active communication on main serial port.

STATUS (red) This LED indicates a NO READ result.

During the reader startup (reset or restart phase), all the LEDs blink for one second.

On the back of the reader near the cable, the “POWER ON” LED indicates the laser scanner is correctly powered.

NOTE

When entering the X-PRESS™ interface on the DS4800 Oscillating Mirror remains in the default

fixed position (0°) in order to make barcode reading easier while performing the X-PRESS™

functions.

AUTO LEARN

If you are configuring your scanner using X-PRESS™, you must start with the

Auto Learn procedure.

1. Enter the

Auto Learn function by holding the X-PRESS™ push button pressed until the LEARN LED is on.

2. Release the button to enter the

Auto Learn function.

Once entered, the reader starts a procedure to automatically detect and recognize barcodes (by type and

length), which are presented to it (*). The laser turns on and the LEARN LED blinks to indicate the ongoing

process.

green

yellow

red

READY

GOOD

RIGGER

COM

STATUS

SETUP

LEARN

EST

FOCUS

Figure 5 – X-PRESS™ Interface: Auto Learn Function

The procedure is as follows:

place the desired barcode on the scanline.

wait until the LEARN LED stays steady on

(indicating the reader has detected the barcode).

repeat, if needed, the above two steps to

program up to 10 different barcodes (the LEARN

LED returns to the blinking state for the next

code). If more than one barcode is detected in

the scan line, the Multi Label mode is enabled

(refer to the “2K/4K Family Software

Configuration Parameter Guide” Help file).

Exit the process by pressing the X-PRESS™ push button once. The scanner will restart at the end of the

process, and then the detected barcodes are automatically configured in scanner memory.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments

Datalogic DS4800 Technical Information Page 8

Comments to this Manuals

Related products and manuals for Toy parts Datalogic DS4800