Datalogic Matrix 400 Instruction Manual download pdf (Page 9)

MATRIX 400™ QUICK GUIDE

STEP 6 – X-PRESS™ CONFIGURATION

Once Matrix 400™ has calibrated image density, you can configure it for optimal code reading relative to your

application. This configuration can be performed either through the X-PRESS™ Interface or the VisiSet™

configuration program.

LOCATE

1. Enter the Focus function by pressing and holding the X-PRESS™ push

button until the Focus LED is on.

2. Release the button to enter the Focus function. The Blue Diamonds™

turn on.

3. Select a code from your application. Position the code at the center of

the FOV (equidistant from the Blue Diamonds™).

4. Exit the Focus function by pressing the X-PRESS™ push button once.

The Blue Diamonds™ turn off.

READY

green

ellow

red

SETUP

FOCUS

LEARN

GOOD

RIGGER

COM

STATUS

Figure 12 – X-PRESS™

Interface: Locate Function

SETUP

5. Enter the Setup function by pressing and holding the X-PRESS™ push

button until the Setup LED is on.

6. Release the button to enter the Setup function. The Setup LED will blink

until the procedure is completed.

The Setup procedure ends when the Image Acquisition parameters are

successfully saved in the reader memory, the Setup LED will remain on

continuously and Matrix 400™ emits 3 high pitched beeps.

If the calibration cannot be reached after a timeout of about 5 (five) seconds

Matrix 400™ will exit without saving the parameters to memory, the Setup

LED will not

remain on continuously but it will just stop blinking. In this case

Matrix 400™ emits a long low pitched beep.

7. Exit the Setup function by pressing the X-PRESS™ push button once.

READY

green

ellow

red

SETUP

FOCUS

LEARN

GOOD

RIGGER

COM

STATUS

Figure 13 – X-PRESS™

Interface: Setup Function

LEARN

8. Enter the Learn function by pressing and holding the X-PRESS™ push

button until the Learn LED is on.

9. Release the button to enter the Learn function. The Learn LED will blink

until the procedure is completed.

The Learn procedure ends when the Image Processing and Decoding

parameters are successfully saved in the reader memory, the Learn LED

will remain on continuously, the Green Spot is activated and Matrix 400™

emits 3 high pitched beeps.

If the calibration cannot be reached after a timeout of about 3 (three)

minutes Matrix 400™ will exit without saving the parameters to memory,

the Learn LED will not

remain on continuously but it will just stop blinking. In

this case Matrix 400™ emits a long low pitched beep.

10. Exit the Setup function by pressing the X-PRESS™ push button once.

READY

green

ellow

red

SETUP

FOCUS

LEARN

GOOD

RIGGER

COM

STATUS

Figure 14 – X-PRESS™

Interface: Learn Function

If you have used this procedure to configure Matrix 400™ go to step 9.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Datalogic Matrix 400 Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Networking Datalogic Matrix 400