Datalogic Matrix 400 Instruction Manual download pdf (Page 18)

MATRIX 400™ QUICK GUIDE

APPENDIX

X-PRESS™ is the intuitive Human Machine Interface designed to improve ease of installation and maintenance.

Status and diagnostic information are clearly presented by means of the five colored LEDs, whereas the single

push button gives immediate access to the following relevant functions:

• Learn to self-detect and auto-configure for reading unknown codes

• Setup to perform Exposure Time and Gain calibration.

• Focus/Locate to turn on the Blue Diamonds™ to aid focusing and positioning.

• Test with bar graph visualization to check static reading performance

In normal operating mode the colors and meaning of the five LEDs are illustrated in the following table:

READY (green) This LED indicates the device is ready to operate.

GOOD (green) This LED confirms successful reading.

TRIGGER (yellow) This LED indicates the status of the reading phase.

COM (yellow) This LED indicates active communication on main serial port.

STATUS (red) This LED indicates a NO READ result.

During the reader startup (reset or restart phase), all the LEDs blink for one second.

On the connector side of the reader near the cable, the blue POWER ON LED indicates the reader is correctly

powered.

For Ethernet models, on the connector side of the reader near the Ethernet connector, the orange ETHERNET

NETWORK PRESENCE LED indicates the on-board Ethernet network connection.

Figure 19 – Power and On-Board Ethernet Network LEDs

On-board Ethernet

Network LED

Power LED

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Datalogic Matrix 400 Instruction Manual Page 18