Datalogic QS6500BT Specifications download pdf (Page 16)

Bluetooth Models

6 QuickScan

QS6500/QS6500BT

Unlinking

There are three ways to unlink an imager from a Base Station:

Unlink and Sleep

1. Scan the “Unlink and Sleep” bar code — Reading the unlink bar code

above while the imager is in range of the Base Station will break

the link between the two devices and allow another imager to link

to the Base Station. It will also place the imager in Sleep Mode. If

the bar code is read when the imager is out of range of its linked

Base Station, the imager will unlink, but the Base Station will

remain linked to the imager and will not allow another imager to

be linked to it until the unlink button is pressed, the original

imager is brought in range, linked, and then unlinked again.

Push the button on the bottom of the Base Station — Pushing the but-

ton on the Base Station while the imager is in range will break the

link between the devices. If the button is pushed while the imager

is out of range, the Base Station will unlink and make itself avail-

able to other imagers. The imager will not automatically break its

link with the Base Station, but can be linked to any other Base Sta-

tion by reading its link label .

Scan the link label on an alternate Base Station — Scanning the link

label on a Base Station with an imager that is linked with another

Base Station will drop the link between the original pair and estab-

lish a link between the imager and the new Base Station. If the new

link is performed within range of the old Base Station, it is free to

establish a link to the next imager that reads its link label. If it is

done outside the range of the old Base Station, it retains its old link

and will not allow a new imager to link to it until its unlink button

is pressed.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 335 336

No comments

Datalogic QS6500BT Specifications Page 16