Datalogic POWERSCAN PD7100 Specifications download pdf (Page 322)

Symbologies

312 PowerScan

PD7100 Corded

Code 93 — cont.

Code 93 Set Length 2

This feature specifies one of the barcode lengths for Code 93 Length Control. Length 2

is the maximum label length if in Variable Length Mode, or the second fixed length if

in Fixed Length Mode. Length includes the barcode’s check, data, and full-ASCII shift

characters. The length does not include start/stop characters.

The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length

(only one fixed length).

Follow these instructions to set this feature:

1. Determine the desired character length (from 1 to 50 — or 0 to ignore this length). Pad

the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,

etc.

2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

Mode.

3. Scan the barcode: SELECT CODE 93 LENGTH 2 SETTING.

4. Scan the appropriate two digits from the keypad in the Keypad Appendix that represent

the length setting which was determined in the steps above. You will hear a two-beep indi-

cation after the last character.

5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See the table below for some examples of how to set this

feature.

Table 42. CODE 93 Length 2 Setting Examples

NOTE

If you make a mistake, before the last character scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

STEP ACTION EXAMPLES

1 Desired Setting

00 (Ignore This

Length)

07 Characters 15 Characters 50 Characters

2 Scan ENTER/EXIT PROGRAMMING MODE

3 Scan SELECT CODE 93 LENGTH 2 SETTING

Scan Two Characters From the

Keypad Appendix

‘0’ and ‘0’ ‘0’ and ‘7’ ‘1’ and ‘5’ ‘5’ AND ‘0’

5 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 317 318 319 320 321 322 323 324 325 326 327 ... 391 392

No comments

Datalogic POWERSCAN PD7100 Specifications Page 322