Datalogic POWERSCAN PD7100 Specifications download pdf (Page 49)

Flash Off Time

Product Reference Guide 39

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash Mode. The se-

lectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond in-

crements.

Follow these instructions to set this feature.

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result

with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-

ming Mode.

4. Scan the barcode: SELECT FLASH OFF TIME SETTING.

5. Scan the appropriate two digits from the keypad in Appendix E, Keypad, that repre-

sent the duration which was determined in the steps above. You will hear a two-

beep indication after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-

ming Mode.

This completes the procedure. See Tabl e 6 for some examples of how to set this feature.

Table 6. Flash Off Time Setting Examples

NOTE

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

STEP ACTION EXAMPLES

1 Desired Setting 500ms 1,000ms (1 sec.) 5200ms (5.2 sec.) 9,900ms (9.9 sec.)

Divide by 100 (and pad with

leading zeroes to yield two digits)

05 10 52 99

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT FLASH OFF TIME SETTING

Scan Two Characters From

Appendix E, Keypad

‘0’ and ‘5’ ‘1’ and ‘0’ ‘5’ and ‘2’ ‘9’ and ‘9’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 391 392

No comments

Datalogic POWERSCAN PD7100 Specifications Page 49