Datalogic GryphonD432 Instruction Manual download pdf (Page 10)

DATALOGIC

DISCONNECTING THE CABLE

USB INTERFACE CONFIGURATION

The USB interface is compatible with:

Windows 98 (and later) IBM POS for Windows

Mac OS 8.0 (and later) 4690 Operating System

START-UP

As with all USB devices, upon connection, the Host performs several checks by

communicating with the Gryphon™ D432/D432E. During this phase the green

LED on the Gryphon™ D432/D432E reader blinks and normal operations are

suspended. Two basic conditions must be met before Gryphon™ D432/D432E

is ready to read codes: the correct USB driver must be loaded

and sufficient

power must be supplied to the reader.

For all systems, the correct USB driver for the default USB-KBD interface is

included in the Host Operating System and will either be loaded automatically or

will be suggested by the O.S. and should therefore be selected from the dialog

box (the first time only).

If the Host supplies sufficient power to the reader, the start-up phase ends

correctly, the green LED stops blinking and the reader emits the beep OK

signal.

If the Host does not supply sufficient power to the reader, a dialog box will

appear on the Host and the reader will be blocked (green LED continues

blinking). In this case, disconnect the USB cable at the Host

(green LED stops

blinking), connect and power-up an external supply to USB cable then

reconnect the USB cable to the Host and close the dialog box. The reader emits

the beep OK signal. You can now read codes. At this point you can read the

USB interface configuration code according to your application. Load drivers

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

No comments

Datalogic GryphonD432 Instruction Manual Page 10