Datalogic Magellan 8500Xt Service Manual download pdf (Page 12)

8 Magellan

8500Xt

EAS Mode Programming Instructions

The barcodes below control the mode of operation for interfacing with the Sensor-

matic

AMB-9010EAS controller (EAS-equipped units only). To select one of the

two modes, simply scan the desired bar code from this page while obscuring the

other (unused) bar code by either folding the page or covering it with a blank piece

of paper. You will not need to scan a "Switch" bar code or perform other steps to

configure the scanner's EAS mode.

Refer to the Product Reference Guide (PRG) for other programming features and

scanner configuration. The PRG is available for viewing and/or download at the

website listed on the back cover of this manual, or contact Datalogic to purchase a

printed copy of the manual.

COUPLED EAS Mode

When in the COUPLED EAS Mode, the bottom-most LED on the scanner will

show sold green, then change to red when an active EAS label is near the Sensor-

matic antenna.

Scan the bar code below to enable COUPLED Mode.

DISABLE EAS Mode

Scan the bar code below to DISABLE the EAS Mode. The scanner's bottom-most

LED will not illuminate and the scanner will operate independently (as if no Sen-

sormatic EAS equipment were installed).

³000000580100000

³000000580000000

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Datalogic Magellan 8500Xt Service Manual Page 12