Datalogic Hand-held devices II User Manual download pdf (Page 96)

RF EXPOSURE INFORMATION (SAR)

This model device meets the government’s requirements for exposure to radio

waves. This device is designed and manufactured not to exceed the emission

limits for exposure to radio frequency (RF) energy set by the Federal

Communications Commission of the U.S. Government.

The exposure standard for wireless devices employs a unit of measurement

known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC

is 1.6W/kg.

*Tests for SAR are conducted using standard operating positions

accepted by the FCC with the device transmitting at its highest certified power

level in all tested frequency bands. Although the SAR is determined at the

highest certified power level, the actual SAR level of the device while operating

can be well below the maximum value. This is because the device is designed

to operate at multiple power levels so as to use only the power required to reach

the network. In general, the closer you are to a wireless base station antenna,

the lower the power output.

While there may be differences between the SAR levels of various devices and

at various positions, they all meet the government requirement.

The FCC has granted an Equipment Authorization for this model device with all

reported SAR levels evaluated as in compliance with the FCC RF exposure

guidelines. SAR information on this model device is on file with the FCC and

can be found under the Display Grant section of

http://www.fcc.gov/oet/fccid

after searching on the below FCC IDs:

FCC ID: U4SFALX3

This device is compliant with SAR for general population /uncontrolled exposure

limits in ANSI/IEEE C95.1-1999 and had been tested in accordance with the

measurement methods and procedures specified in OET Bulletin 65

Supplement C.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 108 109

No comments

Datalogic Hand-held devices II User Manual Page 96