Datalogic DX6400 Installation Manual download pdf (Page 59)

SOFTWARE CONFIGURATION

On Line Operating Mode

Figure 55 - On Line Mode Selection

This operating mode causes the reader to be connected to an external Presence Sensor

using EXT TRIG/PS A and EXT TRIG/PS B inputs.

During the active phase of the presence sensor, the DX6400 reader tries to acquire and

correctly decode the code.

In case the decoding phase is successful, the barcode characters are transmitted on the

serial interface. Otherwise, a no read message is sent.

Automatic Operating Mode

Figure 56 - Automatic Mode Selection

This operating mode does not require the connection to an external Presence Sensor.

When working in this mode the reader is continuously scanning, while the reading phase is

activated each time a barcode enters the reading zone. The reader stops reading after an N

number of scans without a code.

Barcode characters are transmitted on the serial interface. In case of a failed reading phase

no message is sent to the host computer.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 93 94

No comments

Datalogic DX6400 Installation Manual Page 59