Datalogic DX6400 Installation Manual download pdf (Page 58)

DX6400

After defining the parameter values the following window appears allowing to complete the

reader configuration as follows:

- Saving the configuration to disk;

- Switching to Advanced mode;

- Sending the configuration to the scanner.

Figure 53 - Genius™ Wizard Closing Window

Test Operating Mode

NOTE

This operating mode is not available when DX6400 works as Slave.

Figure 54 - Test Mode Selection

This operating mode causes the reader to be continuously activated allowing to verify its

reading features and its reading position with respect to the barcode. For this reason, it is

particularly advised during the installation phase of the reader.

After 100 scan, the values relative to an internal counter and the decoded code are displayed

and transmitted on the serial interface. The counter reports the percentage of good reads of

the label.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 93 94

No comments

Datalogic DX6400 Installation Manual Page 58