Datalogic QuickScanQS6500BT Specifications download pdf (Page 226)

Symbologies

6-138 QuickScan

QS6500/QS6500 BT

Code 11 — continued

Code 11 Data Group Characters

Once you’ve pre-set your desired Data Group Characters

using the Data

Group Characters

feature found in Chapter 5, Data Editing, you can choose

to output up to two of those pre-sets whenever a Code 11 bar code is

scanned.

To set this feature:

1. Determine which Data Group pre-set(s) to output. You can select

up to two from the following:

Data Group 1 * Data Group 2 * Data Group 3 * Data Group 4

For example, your choice might be Data Group 2 only; Data

Groups 1 and 3; Data Groups 3 and 4; or no Data Groups.

2. Scan the START bar code to place the imager in Programming

Mode.

3. Scan the SET CODE 11 DATA GROUP CHARACTERS bar

code.

4. Turn to

Appendix B, Alpha-Numeric Pad and scan the digits repre-

senting the Data Group designation(s) chosen in the first step

above. A digit of value zero (0) selects “no group.” For example,

scanning 3 and 0 would output only the character(s) set for Data

Group 3 whenever a Code 11 bar code was scanned. Scanning dig-

its 1 and 2 would output both Data Groups 2 and 3. To select no

Data Groups at all, scan 0, then 0 again.

5. Scan the SET bar code to accept the digits scanned.

6. Scan the END bar code to exit Programming Mode.

1. In that chapter, you can select which character(s) and position(s) to place Data Characters

within scanned data output.

NOTE

The options in this section set Data Group Characters

for the Code 11 symbology ONLY. If you wish to enable

this feature for additional symbologies, turn to the

options in the section specific to the other symbol-

ogy(s).

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 335 336

No comments

Datalogic QuickScanQS6500BT Specifications Page 226