Datalogic Matrix 200 Instruction Manual Page 7
- Page / 121
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
COMPLIANCE
For installation, use and maintenance it is not necessary to open the reader.
EMC COMPLIANCE
In order to meet the EMC requirements:
• connect reader chassis to the plant earth ground by means of a flat copper braid shorter
than 100 mm;
• for CBX connections, connect the pin "Earth" to a good Earth Ground;
• for direct connections, connect the main interface cable shield to pin 1 of the 25-pin
connector.
POWER SUPPLY
ATTENTION: READ THIS INFORMATION BEFORE INSTALLING THE PRODUCT
This product is intended to be installed by Qualified Personnel only.
This product is intended to be connected to a UL Listed Computer which supplies power
directly to the reader or a UL Listed Direct Plug-in Power Unit marked LPS or “Class 2”, rated
10 to 30 V, minimum 500 mA.
LED CLASS
Class 1 LED Product to EN60825-1:2001
CE COMPLIANCE
Warning: This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
FCC COMPLIANCE
Modifications or changes to this equipment without the expressed written approval of Datalogic could
void the authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference which may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
vii
- MATRIX 200™ 1
- CONTENTS 3
- REFERENCES 6
- COMPLIANCE 7
- HANDLING 8
- GENERAL VIEW 10
- 1 RAPID CONFIGURATION 11
- RAPID CONFIGURATION 13
- USB Models 14
- STEP 3 – AIM THE READER 17
- STEP 7 – TEST MODE 23
- Host Mode Programming 24
- Alternative Layouts 24
- Code Quality Verification 24
- 2 INTRODUCTION 25
- INTRODUCTION 27
- 2.3 ID-NET™ 29
- 2.4.1 X-PRESS™ Functions 32
- Test Mode (Function 1) 33
- Aim/Locate (Function 2) 33
- Setup (Function 3) 34
- Learn (Function 4) 34
- 2.5 MODEL DESCRIPTION 34
- 2.6 ACCESSORIES 35
- 2.7 APPLICATION EXAMPLES 35
- 3 INSTALLATION 38
- 3.2 MECHANICAL DIMENSIONS 39
- INSTALLATION 41
- CBX ELECTRICAL CONNECTIONS 43
- 4.2 MAIN SERIAL INTERFACE 44
- 4.2.1 RS232 Interface 45
- CBX100/500 Function 46
- 4.3 ID-NET™ INTERFACE 49
- 4.3.1 ID-NET™ Cables 49
- 4.3.2 ID-NET™ Response Time 50
- Function 55
- PH-1 Photocell (PNP) 56
- Input Device 57
- Output Device 59
- 4.7 USER INTERFACE - HOST 60
- 5.1 25-PIN CONNECTOR 61
- 5.2 POWER SUPPLY 62
- 5.3 MAIN SERIAL INTERFACE 62
- 5.3.1 RS232 Interface 63
- Matrix 200™ 64
- 6.5) exploiting 65
- Pin Name Function 65
- CAUTION 66
- 5.4 ID-NET™ INTERFACE 67
- 5.4.1 ID-NET™ Cables 67
- 5.4.2 ID-NET™ Response Time 68
- 5.6 INPUTS 73
- 5.7 OUTPUTS 76
- 5.8 USER INTERFACE 78
- 6 TYPICAL LAYOUTS 79
- 6.2 PASS-THROUGH 81
- External Trigger 82
- Fieldbus Interface 84
- 6.4 RS232 MASTER/SLAVE 85
- 6.5 MULTIPLEXER 86
- TYPICAL LAYOUTS 87
- 7 READING FEATURES 88
- READING FEATURES 89
- CAUTION: 90
- 8 SOFTWARE CONFIGURATION 91
- 8.3 STARTUP 92
- 8.3.1 VisiSet™ Options 93
- 8.4 CONFIGURATION 95
- MATRIX 200™ REFERENCE MANUAL 100
- 8.4.3 Calibration 101
- Over-exposure: 103
- Exposure Time 103
- Not Readable 105
- Readable 105
- SOFTWARE CONFIGURATION 107
- Image Filter 108
- 8.6 STATISTICS 109
- 9 MAINTENANCE 110
- 10 TROUBLESHOOTING 111
- 11 TECHNICAL FEATURES 114
- SOFTWARE FEATURES 115
- CODE QUALITY VERIFICATION 115
- USER INTERFACE 115
- GLOSSARY 116
- DECLARATION OF CONFORMITY 120
Related products and manuals for Bar code readers Datalogic Matrix 200
(28 pages)
(2 pages)
(18 pages)© 2020, manymanuals.com. All rights reserved. | 0.783 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals