Datalogic MAGELLAN 8400 Specifications download pdf (Page 44)

2-28 Magellan

8300/8400

3. Rotate the Interior Lift Handle up as shown in Figure 2-23 and

hook the fingers of both hands in the lift handles indicated. DO

NOT attempt to lift the unit using the plastic edges, scale frame, or

any features other than the lift handles.

4. Lower the unit into the counter opening, ensuring that none of the

cables are pinched, pierced or crimped.

5. Re-install the Platter and verify that it is flush or just below flush

with the countertop. This is necessary to provide smooth scanning

from either direction. Make adjustments as needed to align the plat-

ter with the counter by moving support rails up or down, or con-

sider installing screws in positions that will allow their use in

adjusting the unit’s position.

6. Once installation is complete, proceed with the Scale Diagnostic

Mode procedures that follow.

Figure 2-23. Using the Lift Handles

NOTE

Failure to install a scanner/scale in a stable and level position will inhibit

weighing, calibration and zeroing operations. The platter MUST make unob-

structed contact with all of its supports for proper weighing operation.

Rear Lift

Handle

Interior Lift Handle

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 93 94

No comments

Datalogic MAGELLAN 8400 Specifications Page 44