Datalogic CBX800 Installation Manual download pdf (Page 5)

CBX800 INSTALLATION MANUAL

ACCESSORIES

The following accessories are available on request for the CBX800:

Name Description Part Number

BM200/210 Ethernet TCP/IP Module STD/IP65 93ACC1851, 93ACC1852

BM300/310 Profibus Module STD/IP65 93ACC1810, 93ACC1811

BM400 DeviceNet Module IP65 93ACC1814

BM500/510/520 Ethernet/IP Module STD/IP65/IP54 93ACC1812, 93ACC1813, 93ACC1840

BM600 CANopen Module STD 93ACC1815

BM700 Profinet Module STD 93ACC1816

BM1100 CC-Link Module STD 93ACC1845

BM1200/1210 Modbus TCP STD/IP65 93ACC1848, 93ACC1849

BA100 DIN Rail Adapters 93ACC1821

BA200 Bosch Adapters 93ACC1822

BA900 Two Cable Glands Panel 93ACC1847

ADP-FF1 Gender Changer 25P F/F (5 pcs) 93ACC1827

SUPPORTED READING DEVICES

The CBX800 can be directly connected to all of the following readers through the 25-pin connector illustrated in

Figure A.

Linear Scanners 2D Readers

DS6300 DS6400 DX6400 MATRIX-2000™

DS8100A DX8200A

NOTE

CBX800 is backward compatible with DS2100N/DS2400N (black body), DS4600A, and

DS1100/DS2200 10-30 Vdc model reading devices using the ADP-MM1 25-pin gender changer.

See the Gender Changer documentation for the relative CBX pinout.

NOTE

For 6K and 8KA Series devices, the software update Package 6.62 allows the 6K/8KA readers to

work in a 57.6 Kbps (Low-Speed) ID-NET™ network through a passive CBX100 connection box

as Slaves. This requires the entire ID-NET™ network to be configured with this baudrate.

For Full-Speed ID-NET™ operation use CBX800.

A Hand-Held reader can also be connected to the 25-pin connector and have its data passed through to the Host or

ID-NET network.

OPENING THE CBX800

To install the CBX800 or during normal maintenance, it is necessary to open it by unscrewing the four cover

screws:

CAUTION

The CBX800 must be disconnected from the power supply during this operation.

1 2 3 4 5 6 7 8 9 10 ... 33 34

No comments

Datalogic CBX800 Installation Manual Page 5