Datalogic CBX800 Installation Manual download pdf (Page 14)

CBX800 INSTALLATION MANUAL

ELECTRICAL CONNECTIONS

POWER SUPPLY

CBX00 can accept power from the connected reading device through the 25-pin connector, or through the

dedicated spring clamp connector (see section Power Source Jumper Settings).

The default jumper setting, requires power to be supplied to the CBX800 through the Vdc and GND pins provided

on the spring clamp terminal connector as shown in Figure 13:

V+

Earth

Ground

Power Supply

VGND

Figure 13 - Power Supply Connections

The power must be between 10 and 30 Vdc only.

HOST INTERFACE

CAUTION

Do not connect to the Host Interface spring clamp terminals if using Host Interface Modules

(Fieldbus and non Fieldbus) with the CBX800.

Figure 14 – Host Interface Module

The signals relative to the following Serial interface types are available on the CBX800 spring clamp terminal

blocks.

The Host serial interface type and its parameters (baud rate, data bits, etc.) can be defined by the user via

Genius™ software. The RS485 half duplex is automatically set whenever MUX32 communication protocol

is enabled. For more details refer to the "Communication Settings" section in the Genius™ Help On Line.

Details regarding the connections and use of the interfaces are given in the next paragraphs.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

No comments

Datalogic CBX800 Installation Manual Page 14