Datalogic Rhino-NET 40012 User Manual download pdf (Page 20)

RHINO™

1.9 POWER SUPPLY

Vehicle power input for the RHINO™ can range from 11 to 75VDC and is accepted without

the need to perform any adjustments within the RHINO™.

If 11 to 75V DC power is not available – for example, in an office environment – an optional

external FP18 Power Supply can be used to convert AC wall power to an appropriate DC

level. See the section titled “Installation”, sub-section “External Power Supply.”

Power input is protected from fuse externally accessible.

1.9.1 Backup Battery

The internal Lithium (Li) backup battery provides power to the internal clock when primary

power supply has been depleted, removed or has failed. The battery is not rechargeable and

requires no user intervention other than periodic replacement. Replacement is performed by

authorized personnel only. The average duration of backup battery can be 3 years after

stand-by or normal usage.

1.10 CONNECTORS

All external connectors for the RHINO™ are located on the bottom of the unit.

COM 1 port connects any EIA RS232 device. It also can be wired to connect a scanner

COM 2/Scanner port has been designed to connect and power a scanner with 5V power

supply on pin 9. This port can also be used to connect RS232 devices that are not influenced

by the 5V provided on pin 9 of the COM2/Scanner connector.

The maximum current allowed is 1 A @ 5 VDC; therefore, do not exceed this value.

The following tables illustrate the pinout for COM1 and COM2/Scanner ports respectively:

COM1

Pin Function Type

1 DCD Input

RX Input

TX Output

DTR Output

GND Ground

DSR Input

RTS Output

CTS Input

RIN Input

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 48 49

No comments

Datalogic Rhino-NET 40012 User Manual Page 20